IJERI


Cutting Edge Journal of Research and Innovation in Engineering

Volume 2, Number 2, Fall/Winter 2010

CLICK HERE TO DOWNLOAD IN PDF FORMAT.

TABLE OF CONTENTS

Evaluation of a Software-Configurable Digital Controller for the Permanent-Magnet - 5
Synchronous Motor Using Field-Oriented Control
Shiyoung Lee, Pennsylvania State University Berks Campus; Byeong-Mun Song, Baylor University;
Tae-Hyun Won, Dongeui Institute of Technology

Effect of The Number of LPC Coefficients on The Quality of Synthesized Sounds - 11
Hung Ngo, Texas A&M University-Corpus Christi; Mehrube Mehrubeoglu, Texas A&M University-Corpus Christi

Laser-Assisted Uncalibrated Vision Guide Robotic De-palletizing - 17
Biao Zhang, Corporate Research Center ABB Inc.; Steven B. Skaar, University of Notre Dame

State Agencies’ Status of Warm Mix Asphalt Technologies: A Review - 25
Sofia M. Vidalis, Penn State University-Harrisburg; Rajarajan Subramanian, Maryland Department of Transportation

Non-branching Solutions for the Design of Planar Four-bar Linkages Using Task Velocity Specifications - 33
Nina P. Robson, Texas A&M University; J. Michael McCarthy, University of California, Irvine

Streamline Compositional Simulation of Gas Injections - 42
Dacun Li, University of Texas of the Permian Basin

Math Co-processor Efficiency and Improvements on a Multi-Core Microcontroller - 49
Adam Stienecker, Ohio Northern University; Matthew Lang, Ohio Northern University

A Machine Learning Approach for Automated Document Classification: A Comparison - 53
between SVM and LSA Performances
Tarek Mahfouz, Ball State University; James Jones, Ball State University; Amr Kandil, Purdue University

Six Sigma-based Quality Control Laboratory for Engineering and Technology Education Innovation - 63
Richard Y. Chiou and Michael Mauk, Drexel University; Yongjin Kwon, Ajou University

A Simulation Environment for the Evaluation of Airborne Bistatic Radar Concepts for External Hazard Detection - 72
Roland W. Lawrence, Old Dominion University

Comparison of Regression Models to Study Effect of Turning Parameters on the Surface Roughness .................................... 80
Ravindra Thamma, Central Connecticut State University